Technical Characterization of 33 kVA Porcelain Insulators Produced from Enohia and Nsu Clay

Porcelain bodies were developed from mixtures of Nsu clay from Ehime Mbano Local Government Area of Imo state, Enohia clay from Enohia Itim Afikpo Local Government area of Ebonyi state, Ajaokuta feldspar from Kogi state and Otammiri river sand from Ihiagwa in Owerri west Local Government Area of Imo State. Batch A1 contained 50% of Nsu clay, 30% of feldspar and 20% of quartz. Batch A2 contained 45% of Nsu clay, 35 of feldspar, 19% of quartz, and 1% of talc. Batch A3 contained 55% of Nsu clay, 25% feldspar, 19% of quartz, and 1 % of talc. Batch B1 contained 50% of Enohia clay, 30 % of feldspar, and 20% of quartz. Batch B2 contained 45% Enohia clay, 35 of feldspar, 19% of quartz and 1 % of talc. Batch B3 contained 55 of Enohia clay, 25 of feldspar, 19 % of quartz, and 1 % of talc. Batch C1 contained 25% of Nsu clay, 25% of Enohia clay, 30 of feldspar, and 20% of quartz. Batch C2 contained 22.5 % of Nsu clay, 22.5 % of Enohia clay, 35 % of feldspar, 19 % of quartz, and 1 % of talc. Batch C3 contained 27.5% of Nsu clay, 27.5 % of Enohia clay, 25 % of feldspar, 19 % of quartz, and 1 % of talc. The raw clays were analyzed by x-ray diffraction and x-ray fluorescence spectroscopy to determine their mineralogical content and chemical composition. Insulator prototypes as well as test pieces were produced from each batch. The test pieces and prototypes were fired in a kiln up to 1200°C and later subjected to mechanical and electrical parameter tests. Batch C samples which were formulated from equal mixtures of Nsu clay and Enohia clay exhibited a superior mechanical and electrical performance than when each clay sample was used alone. It is recommended to further improve the quality of the starting raw materials by stringent beneficiation procedures, especially to lower the iron oxide content of the raw materials and improve dielectric characteristics of the porcelain products.